[2016-New] Free Sharing Of Updated 400-101 VCE And PDF Dumps From Lead2pass (1-10)

      Comments Off on [2016-New] Free Sharing Of Updated 400-101 VCE And PDF Dumps From Lead2pass (1-10)

2016 July Cisco Official New Released 400-101 Q&As in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

Pass 400-101 exam with the latest Lead2pass 400-101 dumps: Lead2pass 400-101 exam questions and answers in PDF are prepared by our experts. Moreover, they are based on the recommended syllabus that covering all the 400-101 exam objectives.

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/400-101.html

QUESTION 1
In which order of magnitude (time) is delay/latency measured when you use wide metrics in EIGRP?

A.    tens of microseconds
B.    picoseconds
C.    mamoseconds
D.    microseconds

Answer: B

QUESTION 2
Which statement about the BGP synchronization rule is true?

A.    A BGP router with synchronization enabled does not advertise its iBGP learned routes to its iBGP peers unless it has learned or verified this route on its routing table through an IGP.
B.    A BGP router with synchronization enabled does not advertise its eBGP learned routes to its iBGP peers unless it has learned or verified this route on its routing table through an IGP.
C.    A BGP router with synchronization enabled does not advertise its eBGP learned routes to its eBGP peers unless it has learned or verified this route on its routing table through an IGP.
D.    A BGP router with synchronization enabled does not advertise its iBGP learned routes to its eBGP peers unless it has learned or verified this route on its routing table through an IGP.

Answer: D

QUESTION 3
Which tunnel type can be used with encryption to provide security for IPv6 over IPv4?

A.    6RD
B.    6to4
C.    ISATAP
D.    IPv4-compatible
E.    GRE

Answer: E

QUESTION 4
Which QoS mechanism is used to implement CoPP?

A.    RSVP
B.    rate limiting
C.    FIFO
D.    MQC

Answer: D

QUESTION 5
Which two statements about the spanning-tree timers in a switched network are true? (Choose two)

A.    After receiving a BPDU from the root bridge, a non-root bridge waits for the hello interval before forwarding it out.
B.    The root bridge sends out a TCN every max-age interval.
C.    The root bridge sends out a configuration BPDU every hello interval.
D.    The default hello time is two seconds.

Answer: CD

QUESTION 6
Which two statements about Cisco IOS XE are true? (Choose two)

A.    Separate images are required for platform-dependent code.
B.    Its functions run as multiple separate processes in the OS.
C.    It uses a service blade outside Cisco IOS XE to integrate and run applications.
D.    It is deployed in a Linux-based environment.
E.    The FED feature provides separation between the control plane and the data plane.

Answer: BD

QUESTION 7
Which two factors can reduce NBAR2 performance? (Choose two)

A.    queuing
B.    multiple NBAR2-enabled interfaces
C.    slow link speeds
D.    stateful protocol matches
E.    short-duration flows

Answer: DE

QUESTION 8
Which encryption algorithm is enabled by the Cisco IOS command service password-encryption ?

A.    MD5
B.    Cisco Type-5
C.    Cisco AES
D.    Cisco Type-7
E.    TKIP

Answer: D

QUESTION 9
Which two options are requirements for AToM support? (Choose two)

A.    Cisco Express Forwarding must be disabled.
B.    MPLS must be configured with an LSP in the SP core.
C.    MPLS must be enabled between the PE and CE routers.
D.    The PE routers must be able to communicate with each other over IP.
E.    IP routing must be configured between the PE and CE routers.

Answer: BD

QUESTION 10
Which two statements best describes the difference between active mode monitoring and passive mode monitoring? (Choose two.)

A.    Active mode monitoring is the act of Cisco PfR gathering information on user packets assembled into flows by NetFlow.
B.    Active mode monitoring uses IP SLA probes for obtaining performance characteristics of the current exit WAN link.
C.    Passive mode monitoring uses IP SLA to generate probes for the purpose of obtaining information regarding the characteristics of the WAN links.
D.    Passive mode monitoring uses NetFlow for obtaining performance characteristics of the exit WAN links.

Answer: BD

Comparing with others’, you will find our 400-101 exam questions are more helpful and precise since all the 400-101 exam content is regularly updated and has been checked for accuracy by our team of Cisco expert professionals.

2016 Cisco 400-101 exam dumps (All 1119 Q&As) from Lead2pass:

http://www.lead2pass.com/400-101.html [100% Exam Pass Guaranteed]